Using The Viewer Function - NEC MultiSync LT 100 User Manual

Ultra-portable projector

Hide thumbs Also See for MultiSync LT 100:

Table of Contents

Using the Viewer function

If you use the Viewer function on the projector, you must first install

the optional LT Viewer board (VK-LT) in the projector and set up the

exclusive software included with the VK-LT kit.

See the user's manual included with the VK-LT for installing and

uninstalling the software.

Mounting the Optional LT Viewer Board

To install the Viewer board:

1. Switch off the main power and unplug the power cord. Turn the

projector so that the bottom is up.

3. Place the board in place and secure it with the four screws supplied

with the VK-LT board.

2. Remove the screw from the board cover.

4. Attach the two foot caps to adjust projector height. After complet-

ing, put the projector back in the original position.

OPERATION

Table of Contents

Do you have a question about the MultiSync LT 100 and is the answer not in the manual?