b. –WTP: Input signal (CN2-9, 10 pin)
By connecting the CN2-10 pins to the GND, writing operations into the IDD disc media are set
to disable.
4.3.3
Cable connector requirements
Table 4.2 lists the recommended components cable connection.
Applicable
model
MP
SCSI cable (CN1)
Power supply cable
(CN1)
External operator
panel (CN1)
External operator
panel (CN2)
MC
SCSI connector
(CN1)
(1)
SCSI cable
See Section 1.3, "Physical Requirements", and Section 1.4, "Electrical Requirements", in SCSI
Physical Interface Specifications.
(2)
Power cable
IDDs must be star-connected to the DC power supply (one to one connection) to reduce the
influence of load variations.
(3)
DC ground
The DC ground cable must always be connected to the IDD because no fasten terminal dedicated
to SG is provided with the IDD. Therefore, when SG and FG are connected in the system, it is
necessary to connect SG and FG at the power supply or to connect SG of the power supply to FG
of the system.
4 - 26
Table 4.2
Recommended components for connection
Name
Cable socket
786090-7
(closed-end type)
Signal cable
—
Cable socket
1-480424-0
housing
Contact
170121-4
Cable
AWG20
Cable socket
FCN-723J012/2M
housing
Contact
FCN-723J-G/AM
Cable
AWG26 to 34
Cable socket
FCN-723J016/2M
housing
Contact
FCN-723J-G/AM
Cable
AWG28
Connector
787311-1
C141-E103-01EN
Par number
Manufacturer
AMP
—
AMP
AMP
Fujitsu Limited
Fujitsu Limited
Fujitsu Limited
Fujitsu Limited
AMP
Reference
(Figures 4.25
and 4.30)
S1
S2
S3
S4