Fujitsu MAH3182MC Maintenance Manual page 100

5. The saved value of the MODE SELECT parameter is assumed as the
initial value of each parameter after the power-on, the RESET condition,
or the BUS DEVICE RESET message.
parameter value temporary (actively) at any timing by issuing the MODE
SELECT or MODE SELECT EXTENDED command with specifying "0"
to the SP bit in the CDB.
(1) Error recovery parameter
The following parameters are used to control operations such as IDD internal error recovery:
a. Read/write error recovery parameters (page code = 1)
• AWRE:
• ARRE:
• TB:
• EER:
• PER:
• DCR:
• Retry count at read operation
• Retry count at write operation
• Recovery time limit
b. Verify error recovery parameters (page code = 7)
• ERR:
• PER:
• DTE:
• DCR:
• Retry count at verification
c. Additional error recovery parameters (page code = 21)
• Retry count at seek error
Parameter
Automatic alternate block allocation at Write
operation
Automatic alternate block allocation at read
operation
Uncorrectable data transfer to the INIT
Immediate correction of correctable error
Report of recovered error
Suppression of ECC error correction
Parameter
Immediate correction of recoverable error
Report of recovered error
Stop of command processing at successful
error recovery
Suppression of ECC error correction
Parameter
C141-E103-01EN
The INIT can change the
Default value
0 (disabled)
1 (enabled)
1 (enabled)
1 (enabled)
0 (disabled)
0 (Correction is
enabled.)
30 sec
Default value
1 (enabled)
0 (disabled)
0 (Processing is
continued.)
0 (Correction is
enabled.)
Default value
63
63
63
15
5 - 19