System expansions
►
Remove the cover plate from the slot (2).
Do not dispose of the cover plate. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover plate if you remove the board.
►
Make the required settings for the board.
a
2
►
Push the board up to its slot (1) as far as the stop.
►
Press the board into the slot so that it engages.
►
Put the clip on. Make sure that the pin (a) is inserted into the screw hole.
►
Press the clip in the direction of the arrow (2). Make sure that the clip engages when released.
►
If necessary, connect the cables.
►
Close the casing (see "Closing the casing" chapter).
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
34
1
A26361-K680-Z101-1-7419