Working With Floppy Disks - Fujitsu SCENIC S Operating Manual

Preparation for use and operation

Working with floppy disks

Follow the instructions supplied by the vendor of the floppy disks.
!
Never clean the floppy disk drives with cleaning disks. Even one attempt would destroy
the read/write head in the disk drive within 20 seconds.
1
1 = Insertion direction
2 = Label area
3 = Write protection switch for a 720 KB or a 1.44 MB floppy disk
4 = Identification of a 1.44 MB floppy disk or write protect switch on a 120 MB floppy disk
5 = Eject button for inserted floppy disks
6 = Disk is write-protected
7 = Disk is not write-protected
Ê
To insert a floppy disk, push it into the drive in the insertion direction until it engages. The label
should be facing upward.
Ê
To remove the floppy disk, press the eject button (5).
The write-protect switch enables you to protect the data on the floppy disk from inadvertent
overwriting or deletion.
Ê
To protect the data on the floppy disk from being overwritten, push the write-protect switch to
position (6). The hole is now visible.
Ê
To remove write protection, push the switch to position (7). The hole is now covered.
20
5
2
3
Working with floppy disks
6
4
7
A26361-K523-Z100-6-7619