Wireless Network Connection; Wireless Network Setup - Pioneer SBX-N700 Operating Instructions Manual

22 Connecting
En

Wireless network connection

Another connection option is to use an
Access Point or a wireless router. The network
configuration and connection method may vary
depending on the equipment in use and the
network environment.
This unit is equipped with an IEEE 802.11n
(Dual band, 2.4 GHz/5 GHz band) wireless
2
module, which also supports the 802.11a/b/g
standards. For the best wireless performance,
we recommend using a IEEE 802.11n certified
Wi-Fi network (access point or wireless router).
Wireless
Communication
Refer to the setup instructions supplied with
your access point or wireless router for detailed
connection steps and network settings.
For best performance, a direct wired connection
from this unit to your home network's router or
cable/DSL modem is always the best option.
If you do chose to use the wireless option, note
that performance can sometimes be affected
by other electronic devices in the home.
Computer and/or
DLNA certified server
Access Point or
Wireless Router
Broadband
service

Wireless network setup

For the wireless network connection, the unit
needs to be set up for network communication.
This adjustment can be done from the [Initial
Setup] menu. Adjust the [NETWORK] setting
as follow. Setting up the access point or the
wireless router is required before connecting
the unit to the network.
Preparation
Before setting the wireless network, you need to:
- connect the broadband internet to the
wireless home network.
- set the access point or wireless router.
- note the SSID and security code of the
network.
1. Press SETUP.
The Initial Setup screen is displayed.
Select [Network] d [Interface] d [Wireless]
and press ENTER.
2. Select [Network] d [Wireless Setting] d
[Next Screen] and press ENTER.
3. Select [Yes] and press ENTER to continue.
The new connection settings reset the
current network settings.
4. [Wireless Setting] menu is displayed.
Use /b to select [Scan].
5. Then select [Next] using the c/d and press
ENTER.
6. The unit scans the all available access
points or wireless routers within range and
display them as a list. Use /b to select an
access point or wireless router on the list,
and then press ENTER.
If you have security on your access point or
wireless router, verify that the WEP or WPA
key that was entered into the unit matches
the router's information exactly. You need to
input the security code as necessary.