Connecting; Installing The Av Speaker Bar; Mounting The Av Speaker Bar To A Wall - Pioneer SBX-N700 Operating Instructions Manual

16

Connecting

En
Chapter 2
Connecting
Before connecting the unit or changing the
connections, be sure to turn off the power and
disconnect the power cord from the outlet.
Also, make sure you have finished connecting
2
all of the power cords before connecting to the
wall outlet.
Installing the AV
Speaker Bar
Cautions on installing the AV Speaker Bar in front of
a TV
If the AV Speaker Bar is connected in front of a
TV, the TV may not be able to be operated with the
remote control of the TV. In that case, move the AV
Speaker Bar away from the TV if possible.
If operation is not possible with the remote control
of the TV, set [Initial Setup] d [Option] d [IR Out] to
[On] (page 42).
Caution
• Check that the TV cannot be operated with the
remote control of the TV before setting [IR Out] to
[On]. If it is set to [On] when operation is possible,
the signal output directly from the remote control
of the TV and the signal output via the unit will
interfere with each other.
Caution
• Do not install the AV Speaker Bar in an unstable
place such as on an unsteady stand or tilted
surface. It may fall off or tip over, resulting in injury.
• The AV Speaker Bar is not magnetically shielded
and so should be used away from a cathode
ray tube (CRT) TV or monitor. Also, do not place
devices that are easily influenced by magnetism
(magnetic cards, watches, video tapes, etc.) near
the AV Speaker Bar.
 Attaching the Height Adjustment Feet
If you wish to adjust the height of the AV
Speaker Bar attach the supplied height
adjustment feet.
Caution
• When performing the height adjustment feet
attachment work, be sufficiently careful when
handling the parts because there is a risk of
accidental swallowing, suffocation, and injury.
• Choose a level place that is out of the reach of
small children and carry out the work on a soft
surface such as a carpet.
• Take care not to over tighten the mounting screws.
• Match each of the left sides and right sides of the
AV Speaker Bar and feet.
L
L
1. Secure the feet to the AV Speaker Bar
with the supplied screws.
Mounting the AV Speaker Bar
to a Wall
The AV Speaker Bar has mounting holes for
attaching it to a wall.
 Cautions on mounting
The AV Speaker Bar is heavy so there is a risk
that its weight could cause the screws to work
loose or the wall material to fail to support it,
resulting in the AV Speaker Bar falling. Make
sure that the wall you intend to mount the AV
Speaker Bar to is strong enough to support
it. Do not mount the unit to a plywood or soft
surface wall.
Mounting screws are not supplied. Use screws
suitable for the wall material and capable of
supporting the weight of the AV Speaker Bar.
R
R