Step 3 Install Raise/Lower Switch - GE Monogram ZVB36 Installation Instructions Manual

STEP 3 INSTALL RAISE/LOWER SWITCH

WARNING:
Disconnect electrical power from unit before
beginning switch installation. Failure to do so could
result in personal injury or damage to the electrical
controls.
Determine the location for the RAISE/LOWER switch.
The wiring lead is 68" long.
Raise/Lower
Switch
Mounting
Bracket
Pull 3"
Length
Out of
Box
• Drill a 3/8" hole into the desired location. Use the
mounting bracket as a template to locate the hole
accurately. Check for interference between the
switch cover, adjacent objects and cooktop/vent
overlaps.
• If switch is mounted into a tile surface, drill the hole
between tiles. Use locally approved caulking to cover
any gaps.
• Center the mounting bracket over the hole and mark
pilot holes. Remove and drill holes according to type
of countertop.
• Mount the metal switch bracket with screws (not
provided). Choose screws for your type of countertop
or use locally approved adhesive.
• Remove protective film from the top of the switch trim.
• Peel film from the adhesive strips on the back of the
switch trim. Thread the wire lead through the mount-
ing bracket and countertop. Press trim over the
mounting bracket to set the adhesive.
Installation Instructions
Trim
3/8" Hole
2 Pin
Connector
Strain Relief
AVERTISSEMENT
Il faut débrancher l'alimentation électrique de
l'appareil avant de commencer l'installation de
l'interrupteur. Il faut suivre cette directive pour éviter
des blessures ou endommager les commandes
électriques.
Connect Raise/Lower Wire Lead to Wire Box
• Thread wire end with the connector through the
hole on the end of a wire box. Pull approximately
3" additional wire length beyond the open end of
the box.
• Connect the mating wire connectors.
• Install the wire box onto the bottom of the
countertop or directly behind the switch. Use
adhesive or screws appropriate for the type of
countertop.
• Place plastic strain relief over the wire, just outside
of the hole at the end of the wire box. Do not pinch
or twist the wire. Snap the strain relief closed and
press into the hole.
Control
Box
Connect Wire Lead to Control Box
• Thread the long 68" wire lead through the end of the
other wire box.
• Push wire leads into the white connector provided.
• Push wire connector into the mating connector on
the control box. Install the wire box onto the end of
the control box with screws provided.
• Place plastic strain relief over the wire, just outside
of the hole at the end in the wire box. Do not pinch or
twist the wire. Snap the strain relief closed and
press into the hole.
• Coil the excess wire and position away from moving
parts and cabinet contents.
14