Installing The Front Wheels - Joovy Groove 0080X Series Instruction Manual

Joovy groove 0080x series strollers instruction manual
Hide thumbs Also See for Groove 0080X Series:
Table of Contents

Advertisement

Installing the Front Wheels

• Orient the stroller so it is resting on the rear wheels
and the handle bars. Locate one front wheel set
and insert the wheel set onto the plastic housing
located at the end of a front leg until an audible click
is heard. See Figure 4.
• Pull on the wheel to ensure the wheel is installed
properly.
• Repeat this procedure for the other wheel.
• To remove a front wheel, locate the plastic locking
clip located underneath and inside of the front
wheel housing. Press the lock release while pulling
the wheel from the post. See Figure 5.
Front Wheel Locks
The front wheels can be either in swivel mode or
locked mode.
• To put each front wheel set into its locked mode,
push down on the locking lever located between
the wheels until an audible click is heard. See Figure
6. Rotate the wheel set until it locks automatically
in the straight position, and another audible click is
heard.
• To unlock each wheel and put it into swivel mode,
pull up on the lever until an audible click is heard to
disengage the lock.
Installing and Operating the Canopy
• With the stroller open, insert BOTH plastic canopy clips into the canopy slots on the underside of the
stroller frame. Ensure that the clips are fully engaged and secure. See Figure 7.
• Secure the Velcro® tabs at the top of the canopy to the handle tubes. See Figure 8.
• Place the rear apron behind the seat back. Make sure the seat is fully reclined (see page 6). Secure
the Velcro® on each upper side of the apron to the Velcro® on the side of the seat. Then, secure the
Velcro® on each side of the bottom of the apron to the side of the seat back near the seat support
tubes. See Figure 9.
• Open the canopy by pulling the visor forward and then push down on the canopy stretchers to lock
the canopy in the open position. The canopy and visor can be adjusted into several positions ranging
from fully closed to fully extended, or any position in between.
• The visor can be adjusted by pulling (or pushing) it from under the canopy. See Figure 10.
Page 3
Figure 4
Figure 5
Figure 6
Groove Instruction Manual

Advertisement

Table of Contents
loading

Table of Contents