Securing The Child - Joovy Groove 0080X Series Instruction Manual

Securing the Child

NOTE: There are three height adjustment positions for the
shoulder harness straps. For a younger child, the shoulder
harness straps should be positioned through the lower
opening. For a taller child, the shoulder straps should be
positioned through the center or top openings to ensure a
good fit.
• To change the positioning of the shoulder straps, find the
ends of each strap behind the seat back. Twist the buckle
on the end of each strap sideways and push it out toward
the front of the seat back through the slot. To re-assemble
into a different slot position, twist the buckle sideways
and push it through the slot in the seat back from the
front toward the back of the stroller. Release the buckle
and make sure each strap is not twisted. Pull each strap
toward the front of the stroller to be sure it is secure. Be
sure that both shoulder straps are inserted through the
slots at the SAME height.
• Ensure that both shoulder straps are attached to the waist
strap buckles. See Figure 18.
• Unlatch the waist/shoulder buckle by squeezing in on
both sides of the buckle latch and removing the male
ends of each buckle.
• Carefully place the child in the stroller seat with the
shoulder straps over their shoulders and chest. Then
place the crotch strap between the child's legs.
• Bring the seat belt around the child's waist and insert the
male ends of the waist/shoulder buckle into the female
buckle. Ensure that they snap into place. See Figure 19.
Tighten the waist belt to be snug around the child's waist.
• Both the shoulder straps and the waist/crotch straps may
be adjusted using the sliding buckles on these straps.
See Figure 20 and 21.
Avoid serious injury from falling or sliding out. Always use the safety
Page 7
WARNING
!
harness.
Figure 18
Figure 19
Figure 20
Figure 21
Groove Instruction Manual