Installing The Pentium Ii Processor - Acer 1100 User Manual

1.6

Installing the Pentium II processor

The following section will briefly explain and illustrate how to install the
Pentium II processor.
You have to attached the heat sink and fan
before installing the Pentium II processor into
the system board.
1.6.1 Attaching the Processor Heat Sink and Fan
The Pentium II processor module comes with holes on one side to
hold the clips of the heat sink and fan. The upper set of holes (near
the latches) on the processor are wider and should match the wider
ends of the clips on the heat sink. The lower set of holes are smaller
and should match the narrow ends of the heat sink clips.
Wide Holes
Narrow Holes
Figure 1-3 Matching the Fan-Heat Sink Clips with the Holes on
the Processor
1-10
Wide Clip Ends
User's Guide