Cables And Connections; Cable Requirements; 22-Pin Data Cable; 22-Pin Connector Definition - Infinity ISE-XH30/36ZWDN650 FD Instruction Manual

CAMERA SETUPS AND CABLE CONNECTIONS
Switch No.
0
1
2
4
5
7
8
9
11
12
13
14
15
21
22
Select protocol: Pelco D, with switch no. 01 and baud rate 2400, for instance, the protocol switch should be set as
follows:
Decimal Digit Single Digit

CABLES AND CONNECTIONS

6.3
The Dome Camera is supplied with one integrated 22-pin Data Cable for connecting with the power, video, and RS-
485/audio input & audio output cables. Please read the following sections thoroughly before making connections.
42 | ISE-XH30(36)ZWDN650 FD
Protocol Baud Rate
VCL 9600
Pelco D 2400
Pelco P 4800
Chiper 9600
Philips 9600
DSCP 9600
AD422 4800
DM P 9600
Pelco D 4800
Pelco D 9600
Pelco P 2400
Pelco P 9600
JVC 9600
Kalatel-485 9600
Kalatel-422 4800

CABLE REQUIREMENTS

6.3.1
For operation, the Integrated High Speed Dome Cameras require video, RS-485 and power cables as described
below:
• The video cable sends video signals to a remote viewing site. Using a coaxial cable to send video signals is
recommended.
• RS-485 cable carries commands from a control device to the Dome Cameras. A CAT 5, 24 gauge cable is rec-
ommended.
• Power supply: DC 12V/AC 24V output voltage
Note Ensure power supply meets the Dome Camera's power requirement, or product impairment will occur.
If any mistake happens, please contact with a qualified maintenance engineer.

22-PIN DATA CABLE

6.3.2
The analog Speed Dome Camera's Data Cables are illustrated respectively as shown below.
Note: Be careful not to pull the cables improperly during installation. Additionally, it is suggested to fasten
the cables after cable connection is completed. Furthermore, when wiring the AC 24V power cable, make
sure the Ground wire is inserted into the mid-pin of the terminal block.

22-PIN CONNECTOR DEFINITION

6.3.3
With the 22-pin connector, installers can simply connect the power, video and RS-485 cables to the Dome Camera
at once. Particularly, the alarm pins are serviceable for connecting alarm input and output devices, such as alarm
sensors, sirens or flashing lights with the surveillance system. The analog and network Speed Dome Cameras' 22-
pin connector definition will also be specified as follows.
ENG
CAMERA SETUPS AND CABLE CONNECTIONS
ISE-XH30(36)ZWDN650 FD | 43