Camera Setups And Cable Connections; Preparations For Dome Camera Setups - Infinity ISE-XH30/36ZWDN650 FD Instruction Manual

CAMERA SETUPS AND CABLE CONNECTIONS

6.CAMERA SETUPS AND CABLE CONNECTIONS
Before installing or connecting the Dome Camera, please refer to this section and complete preparations for Dome
Camera setups and various switch settings.

PREPARATIONS FOR DOME CAMERA SETUPS

6.1
The following installation procedure is for the outdoor Dome Camera equipped with the sunshield. Please follow the
steps below to install dome cover and detach the Outdoor Mount Kit from the camera body for switch setups.
STEP 1
Unpack the Dome Camera's package and
take out the Dome Camera unit.
STEP 2
Rotate the Outdoor Mount Kit, and take it
off from the camera body.
STEP 3
Remove the protective cover and PE
sheet.
38 | ISE-XH30(36)ZWDN650 FD
STEP 4
Attach the dome cover to the camera body.
Before doing that, apply some lubricant
on the cover's water-proof rubber to make
the installation process smoother.
Note that the tiny protrusion on the dome
cover must align with one of the four holes
on the dome body.
STEP 5
Gently pressure the dome cover downward
with two hands on the side of it.
DO NOT press the cover, as shown in the
figure; this might cause damage to the
camera body.
STEP 6
Screw the dome cover and camera body
together.
STEP 7
Set the switches located on the bottom of
the dome body.
ENG
CAMERA SETUPS AND CABLE CONNECTIONS
ISE-XH30(36)ZWDN650 FD | 39