Burner Removal; Hot Surface Light Removal; Cooling Fan Removal - GE JD966 Technical Service Manual

3. Remove the 5 screws from the top inside edge
of the control panel frame.
4. Open the door and remove the 6 screws under
the control panel.
5. Remove the 2 screws at the front corners of
the burner box.
6. Slide the burner box forward. Remove the
burner box and set it top side down on a
protected surface.

Burner Removal

1. Remove Burner Box (see procedure).
2. Remove the 3 screws and the bottom pan
from the burner box.
Screws Screws Screws
3. Note the position of the wiring and disconnect
from the burner terminals.
Screws Screws Screws
m t e r m i n a l s .
4. Mark the numbers nearest the mounting clips
for reassembly of the new heating element and
remove the screws and clips securing the
burner. Remove the burner.

HOT SURFACE Light Removal

1. Lift up on the 3-wire side of the HOT
2. Slide the unit toward the 3-wire side and

Cooling Fan Removal

1. Remove the burner box (see procedure).
GEA01093 Plastic Clips
Mounting Mounting Mounting
Clips Clips
2. Disconnect the wiring from the fan motor.
3. Use pliers to remove the plastic insulation
GEA01094
4. Remove the 4 mounting screws and the fan.
35
SURFACE light unit.
remove.
Screws Screws
fasteners from the sides of the fan housing.
Wiring Wiring
GEA01096