GE JD966 Technical Service Manual page 35

4. Disconnect the wiring harnesses at the main
connectors.
Wiring Harness Wiring Harness
Connectors Connectors
5. Note the placement of the remaining wires and
harness connectors on the circuit board,
disconnect and remove the control panel.
6. To remove the touch pad, disconnect the
ribbon from the circuit board by squeezing the
locking tabs on the sides of the ribbon
connection and pulling the ribbon lock up.
7. Remove the 4 screws that secure the touch
pad and remove the pad.
Models JS966, JD966
1. Remove the four (4) knobs and the retainer
nuts under the knobs.
Harness Harness
Connector Connector
GEA01081
Ribbon Ribbon
Lock Lock
Ribbon Ribbon
GEA01082
Caution: Lift the panel faceplate enough to
access the wire harness connected to the touch
board.
2. Remove the harness connector from the touch
board by pulling on the connector (do not pull
on the wiring). Remove the faceplate and
place face down on a protected surface.
3. Remove the 4 screws that secure the control
panel.
Note: The control panel can now be tilted down
into service position allowing access to the
electrical components.
4. Disconnect the wiring harnesses at the main
connectors.
5. Note the placement of the remaining wires and
harness connectors on the circuit board,
disconnect and remove the control panel.
33
Touch Board Touch Board
Harness Harness Harness
Connector Connector
GEA01083
Wiring Harness Wiring Harness Wiring Harness
Connectors Connectors Connectors
GEA01084