Maintop Burner Assembly Removal; Spark Module - GE PGS908 Technical Service Manual

Maintop Burner Assembly Removal

The maintop, burners, igniters, igniter switch as-
sembly, and manifold and valves, can be removed
as an assembly. Removing the assembly will require
disconnecting the manifold inlet gas tube from the
manifold.
WARNING
• Disconnect electrical power to the range
and turn OFF gas at the main valve before
performing any removal procedures.
• Sharp edges may be exposed when servicing.
Use caution to avoid injury. Wear Kevlar gloves
or equivalent protection.
To remove the Maintop Burner Assembly:
1. Remove the grates, oven vent cover and cap,
and the 4 burner caps and heads.
2. Remove the oven vent tower. (See
)
moval.
3. Remove the control panel assembly. (See
.)
Panel Assembly
4. Remove the fi ve 1/4-in. hex-head screws from
the top inside edge of the control panel frame.
5. Remove the fi ve 1/4-in. hex-head screws holding
the control panel frame to the maintop baffl e,
then remove the control panel frame.
6. Remove the 1/4-in. hex-head screw that
attaches the ground wire to the burner box and
disconnect the igniter wire harness.
7. Remove the 11/16-in. nut that connects the
manifold inlet gas tube to the manifold.
8. Raise the front of the maintop burner assembly,
slide it to the left. Disconnect the spark module
wire harness. (See
Maintop Re-
9. Remove the assembly and place it top-side-
down on a protected surface.
Control

Spark Module

The spark module receives line voltage when a
surface burner knob is placed in the LITE position.
The line voltage input to the spark module can be
checked on the ERC.
To test for line voltage to the spark module:
1. Place the control panel in the service position.
(See
2. Carefully reinstall the glass touch panel and
connect the ribbon connector.
3. Connect power to the range.
4. Lock out the surface burners (See
Features
5. With a burner knob turned to the LITE position,
test for line voltage (120 Volts) from the yellow
wire at the switch harness to N (neutral) on the
ERC.
– 59 –
Component Locator Views
.)
Touch Panel and ERC
.) or turn off the gas supply.
(Continued next page)
Harness
11/16-in. nut
.)
Control