Command Reference Listing - Trango Systems ATLAS5010 User Manual

Configuration
48
54
In this example the user sets the power to 19dBm and the speed to 24 Mbps:
#> power 19
Execution in progress...
.
19 dBm (-4..19)
Success.
#> speed 24
24 Mbps
Success.
#>

Command Reference Listing

The complete command set reference is provided below. You can also view a complete listing of all CLI commands by
typing help.
antenna [h|v]
arq [on|off]
autorateshift [on|off]
autoscanmu [on|off]
defaultopmode [on|off]
encrypt [on|off]
encrypt key <key>
exit
freq [<ch#> <antenna>]
freq writechannel <ch#> <freq>...
freq writechannel default
Trango Broadband Wireless — ATLAS5010
-75 18
-73 18
Set or display antenna setting. H=Horizontal
polarity, V=vertical polarity.
Enable or disable Auto Retransmit Request
(ARQ). With ARQ enabled, the Atlas system
will retransmit packets which are detected as
missing or corrupted. Default setting=ON.
Enable or disable automatic rate shift feature.
With autorateshift enabled, the radios will
automatically renegotiate speed setting to
maximize wireless link integrity. Default
setting=OFF.
Enable or disable auto scan MU (RU only).
Default setting=OFF . When autoscanmu is
turned on, the RU will automatically scan all
channels and polarizations searching for its peer
MU. Once the RU detects the MU it will stop
scanning and lock onto the channel of the MU.
The autoscan feature is useful in cases where
the user changes the channel at the MU because
the RU will automatically search for the new
channel of the MU. Note: auto-scanning may
take as long as 5 minutes.
Set or display default opmode. Radio must be
set to opmode ON to establish wireless link.
Default setting=OFF
Enable or disable proprietary 128 bit tx
encryption.
Default setting=OFF
Change encryption key (128 bits)
<key> = xxxx xxxx xxxx xxxx
xxxx xxxx xxxx xxxx
Exit telnet session
Set or display channel and antenna selection
Modify channel table, up to 6 channels at a time
Restore factory default channel table
7
7
page 13