Remote Unit Configuration; Establishing A Wireless Link - Trango Systems ATLAS5010 User Manual

Configuration
Ch# 23 h (5815 MHz)
Success.
4. Set default Opmode to ON.
#> defaultopmode on
Success.
5. Turn Opmode ON.
#> opmode on
Success.
.

Remote Unit Configuration

Configure the RU in the same manner as the MU. Since the default unit type (utype) is RU, you do not need to set this
parameter.
1. Set the Peer ID with the MAC address of the MU. Only use the last 8 digits of the MAC address.
#> peerid de
Success.
#>
2. Set channel and polarization. (in this example set the channel to 23 and polarization to H).
#> freq 23 h
Ch# 23 h (5815 MHz)
Success.
3. Set default Opmode to "ON."
#> defaultopmode on
Success.
4. Turn Opmode "ON."
#> opmode on
Success.

Establishing a Wireless Link

If the MU and RU are properly configured and in opmode "ON", the two radios will automatically begin the
authentication process and become connected. To determine if the two radios are connected, type the sysinfo 2
command.
Example:
#> sysinfo 2
********************************* 2 *********************************
[Opmode] off [Default Opmode] off
[Active Channel] 1 h [Freq] 5260 MHz
[Speed] 24 Mbps [Tx Power] 0 dBm [Power Range] -4..19 dBm
[Tx MIR] 50000 Kbps
[ARQ] on
[Encrypt] off [Key] 0011 2233 4455 6677 8899 AABB CCDD EEFF
[Peer ID] DE1B7850
Success.
#>
Trango Broadband Wireless — ATLAS5010
1B7842
[Status] connected
[RSSI] -49 dBm
page 10