Installing The Odd Bay Module; Disassembling The Odd Drive - Toshiba Qosmio F50 Maintenance Manual

4 Replacement Procedures Error! Use the Home tab to apply
appear here. Error! Use the Home tab to apply

Installing the ODD Bay Module

Install the ODD bay module according to the following procedures and Figure 4-10.
1. Place the ODD bay module in the correct position and slide it in.
2. Push it in until it clicks into place.
3. Turn the computer upside down.
4. Secure the ODD bay module with one M2.5x10 screw.

Disassembling the ODD Drive

NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it fails.
Disassemble the ODD drive according to the following procedures and Figure 4-11.
1. Remove two M2x3 screws.
2. Remove the bracket.
Figure 4-11 Removing the bracket from the ODD drive
3. Remove the ODD bezel.
Qosmio F50 Maintenance Manual
2 to the text that you want to
2 to the text that you want to appear here.
4-26