KYMCO Agility 50 Driver Manual page 39

(9) BRAKE FLUID LEVEL INSPECTION /REFILLING (9) BRAKE FLUID LEVEL INSPECTION /REFILLING
Remove the two screws from the brake fluid tank and take Remove the two screws from the brake fluid tank and take
off the cover. off the cover.
Add recommended brake fluid DOT-4 into the tank until Add recommended brake fluid DOT-4 into the tank until
the fluid level reaches the upper limit and then put on the the fluid level reaches the upper limit and then put on the
cover and tighten the screws. cover and tighten the screws.
Recommended Brake Fluid: DOT-4 Recommended Brake Fluid: DOT-4
CAUTION:
Do not mix brake fluid of different brands. It may cause Do not mix brake fluid of different brands. It may cause
brake failure and is very dangerous. When refilling brake brake failure and is very dangerous. When refilling brake
fluid, use towels to cover and protect the painted and fluid, use towels to cover and protect the painted and
coated surfaces. (Replace at 10000km or every year.) coated surfaces. (Replace at 10000km or every year.)
Ｋ Ｋ Ｌ Ｌ
Upper Lime Upper Lime
(10) RUBBER COVER INSPECTION FOR WIRE AND (10) RUBBER COVER INSPECTION FOR WIRE AND
CABLE CABLE
The cable cores are protected by the rubber cover outside The cable cores are protected by the rubber cover outside
the connector. Check the rubber cover frequently for the connector. Check the rubber cover frequently for
proper installation. proper installation.
When washing the motorcycle, do not flush the rubber When washing the motorcycle, do not flush the rubber
cover directly or brush it. Use a wet rag to wipe off dirt cover directly or brush it. Use a wet rag to wipe off dirt
and dust. and dust.
Rubber Cover Rubber Cover
Check Points Check Points
Lower Lime Lower Lime
－ － － －
35 35
Ｋ
Ｌ