Adjusting The Visual Ringer Brightness - Radio Shack 43-140 Owner's Manual

The.Basics
8. Press and push up on the
corded handset holder to lift and
remove it. Turn it over and rotate
it 180°, then slide it down into its
slot and snap it back into place
so it holds the corded handset.
9. Connect the corded handset cord to left side of the base and
to the corded handset. Route the curl cord inside the molded
wiring channel on the bottom of the base.
Adjusting.the.Visual.Ringer.Brightness
Your new phone has visual ringers
located at the top of the base unit and
at the top of the cordless handset.
These visual ringers will flash during
incoming calls, so if you are in a noisy
work environment you will be able to see
when the phone is ringing. The phone
comes with a switch for base visual
ringer control, so you can turn the visual
ringers off when you do not want the
base to flash brightly during incoming calls.
The VISuAL RINgER HI/LO/OFF switch allows you to set the
brightness and turn off the visual ringer on the base. You can
adjust the brightness by selecting one of three options: high, low
and off. If you set the switch to off, the visual ringer on the base
will not flash at all during incoming calls.
UC044ZH_43-140_OM5.indd 19
1
12/18/2006 3:33:54 PM