Table of Contents
Advertisement
3. Press any number other than 0.
Note: If your phone system requires that
you dial an access code (9, for example)
before you dial an outside number, do
not press the access code number
either.
If the dial tone stops, you have touch-
tone service. Leave
.
TONE
If the dial tone continues, you have
pulse service. Set
.
PULSE
4. Press
or place the handset on the
TALK
base to hang up.
TURNING THE BASE'S
RINGER ON AND OFF
To turn off the base's ringer, set
the back of the base to
make or receive calls using this phone. Tele-
phones on the same line (and the phone's
handset if it is away from the base) still ring
when there is an incoming call.
To turn on the base's ringer, set
.
ON
SETTING THE HANDSET
RINGER'S TONE AND
VOLUME
You can set two ringer tones and a high and
low volume for each. To change the tone and
volume, lift the handset and press
9 9 9 9
. The tone sounds for 2
SETTING THE NUMBER OF
RINGS
Set
on the side of the base to
RING TIME
or
(toll-saver) to select how long the an-
TS
swering system waits to answer a call (3
rings, 5 rings, or toll-saver).
Note: If you plan to check messages by long
distance, set
the Toll-Saver" on Page 20).
SETTING THE DAY/TIME
You must set the day of the week and time
so the answering system can record the cor-
rect day and time of each message.
set to
TONE/PULSE
Note: Enter each key press within about 2
minutes. Otherwise, the system exits the
time setting process and you must begin
to
TONE/PULSE
again with Step 1.
on
RINGER
. You can still
OFF
to
RINGER
8 8 8 8
or
VOL
seconds.
Press
the currently set day and time.
Note: When power fails, the clock retains the
current time. When the power is restored, it
3, 5,
starts counting again from the time the power
failed. You must reset the clock to the current
time.
Installation
RING TIME
1. Hold down
CLOCK
beeps. It announces the currently set
day and displays the day's number (0 for
Sunday, 1 for Monday, and so on).
2. To change the day of the week, repeat-
edly press
to move forward or
SKIP
to move backward to the cor-
REPEAT
rect day, then press
CLOCK
3. The system announces the hour. To
change the hour, repeatedly press
or
until the correct hour dis-
REPEAT
plays, then press
CLOCK
4. The system announces the minutes. To
change the minutes, repeatedly press
SKIP
or
REPEAT
until the correct minutes
display, then press
CLOCK
5. The system announces "AM" or "PM,"
and
A
or
P
appears. Press
to change this setting, then
REPEAT
press
. The system beeps and
CLOCK
announces the day and time.
to hear the system announce
CLOCK
to
(see "Using
TS
until the system
.
SKIP
.
.
or
SKIP
11
Advertisement
Table of Contents
