Table of Contents
Advertisement
Available languages
Available languages
The iron has not yet reached the
temperature necessary for ironing.
The steam volume is higher than
necessary.
Limescale
The water is too hard or the utensil
emerges from
has been in use too long without
the steam
descaling.
nozzles.
The anti-limescale cartridge is used
up.
All lamps on the
The utensil has switched off
utensil go out.
automatically.
There is not
The steam chamber has not yet
steam, the
heated up.
pump indicator
The steam volume regulator is at off. Press the button of the steam volume
light goes off
when you press
the steam
button.
The utensil
Mains plug not plugged in or no
cannot be
power.
switched on.
Fuse blows
Utensil defective or too many devices
connected.
8. Cleaning
WARNING
Risk of burns
Before cleaning, always remove the plug and allow the utensil to cool
down. Only clean it when it has cooled down fully.
DANGER
Danger of death from electric shock
Never immerse the steam generator in water or other fluids.
CAUTION
Material damage
Never use aggressive or abrasive cleaning agents.
8.1.
Cleaning after use
•
Place the iron on the rest of the steam generator.
•
Remove water reservoir (1) from the steam station and press steam pressure button
(5) until no more steam comes out. Replace the water reservoir.
•
Switch the iron and the steam generator off and pull out the plug.
•
Rinse out the water tank with clean water.
•
Let the utensil cool down (for about 30 minutes).
•
Wipe off with a damp, soft cloth.
•
Clean all the operating elements and other components also with a soft cloth.
•
The sole can be cleaned with a damp cloth. It is best to use a cloth dipped in distilled
water. Then wipe off the sole clean with a dry cloth. Never use scrubbing pads,
vinegar or chemicals.
•
Protect the sole of the iron against scratching. Do not iron over metal objects such as
buttons or zip fasteners.
BEEM – Elements of Lifestyle
Wait until the temperature control lamp
on the iron no longer flashes.
Set the steam volume as specified in the
table.
Descale the iron as described in section
8.2.
Change the anti-limescale cartridge.
Press the on/off button to switch the
utensil back on.
Wait until the Heat indicator goes out.
regulator until one of the three steam
symbols lights up.
Plug in the mains plug or check the
socket/house fuse.
Contact after-sales service or
reduce number of appliances using the
circuit
23/56
Advertisement
Table of Contents
