Table of Contents
Advertisement
Available languages
Available languages
CAUTION – Material damage
26.
Place the steam generator on a heat-resistant, sturdy, level, water-proof surface.
27.
Always place the steam iron horizontally on the steam generator. The hot iron
may not come into contact with the power cable, the steam pipe or the plastic
parts of the steam generator.
28.
The water tank may only be filled with water. Never fill with other liquids.
29.
Never place the utensil near a gas flame, electric hotplate or other source of
heat. External heat can damage the utensil.
ATTENTION: No liability can be accepted for any damage caused by misuse.
5. Prior to initial use
♦
Ensure that all the packaging has been removed from the utensil (protective foil,
etc.).
♦
Do not remove the rating plate or any warnings.
CAUTION: Check that the utensil is undamaged and that no parts are missing. If
any components are damaged, the utensil should not be used. Contact qualified
service personnel.
♦
Some parts of the utensil carry residue of assembly grease. Therefore there may be
some smell and smoke the first time the utensil is used.
♦
A new iron may splash or spit when using tap water. This stops after using a few
times.
6. Use
•
The automatic switch-off function switches the utensil off after about 20 minutes
if you do not press the steam pressure button. The utensil beeps twice and all the
indicators go out. Press the
•
The anti-drip system prevents water from dripping from the sole of the iron when
the temperature is too low.
However, water still drips if:
the temperature is on the lowest temperature setting and the steam is on.
o
•
The ceramic coated iron sole glides smoothly over the fabric when ironing. Please
bear the following in mind:
Never iron over zip fasteners, rivets or buckles, these can scratch the sole.
o
Wipe off the sole occasionally with a damp cloth. Do not use abrasive
o
cleaning agents.
Always stand the iron on the steam generator for storing.
o
•
The electronic temperature setting ensures an accurate temperature control. The
display flashes whilst the iron is heating up. On reaching the temperature, the
selected temperature level lights continuously. Clicking noises whilst ironing are
normal. Use the table below for setting the temperature and observe the ironing
instructions on the clothing labels.
BEEM – Elements of Lifestyle
button to switch the utensil back on.
19/56
Advertisement
Table of Contents
