Cleaning And Maintenance; Storage - Beem Power Station Pro4 Operating Instructions Manual

Power Station Pro4

Cleaning and maintenance

Before beginning, pay attention to the
safety instructions in the Safety section!
Cleaning the ironing sole
■ Clean the ironing sole with a soft damp
cloth. Subsequently wipe with a soft
dry cloth.
■ Store the appliance with the iron stan-
ding in the base station.
Anti-lime system - filter change
The anti-liming system filter reduces the
formation of calcium deposits in the appli-
ance. Replace the filter after filling the tank
15 to 20 times.
It is recommended to replace the wa-
‹
ter filter immediately before beginning
with ironing.
Press the button upwards to release
‹
the lock of the water tank and pull the
tank to the front and out of the appli-
ance (see figure C1).
Remove the old calcium filter (A) by
‹
pulling it upwards out of the water fil-
ling opening (see figure C2).
Fill the water tank up to the MAX mark
‹
with approx. 1 litre of water (see figure
A3).
Soak the new calcium filter (B) sepa-
‹
rately for a few minutes before inser-
ting it into the tank filled with water.
Insert the new calcium filter into the
‹
water tank (see figure C3).
Push the water tank back into the
‹
appliance until it audibly locks in (see
figure A5).
24

Storage

If you do not intend to use the appliance
for a longer period of time, empty the wa-
ter tank as described in the section Emp-
tying the water tank and clean the appli-
ance as described in the section Cleaning
and care.
Store the appliance on an even, stable
surface. The iron must be standing on the
base station.
BEEM - Elements of Lifestyle
EN