Makita VC1310L Instruction Manual page 9

pulling the hose may cause a breakage or
deformation of the hose.
When picking up large wastes such as planer
•
carvings, concrete dusts or similars other than
small wastes, use the 38 mm inner diameter hose
(optional accessory). Using the 28 mm inner
diameter hose may cause a hose stuffing and
damage.
011590
Insert the hose onto the mounting port of the tank and
turn it clockwise until it locks.
Installing polyethylene bag
Cleaner can also be used without polyethylene bag.
However, using polyethylene bag is easier to empty the
tank without letting your hands dirty.
1
011591
Spread the polyethylene bag in the tank. Insert it
between the holder plate and the tank, and pull it to the
hose inlet.
1
011592
Spread the bag around the top of the tank.
Hook up the other side of the bag around the top of the
tank so that the prefilter hook can catch and hold it
securely
NOTE:
A polyethylene bag available on the market can be
•
used. The 0.04 mm or thicker one is recommended.
1. Holder plate
2. Tank
2
1. Polyethylene
2
bag
2. Holder plate
3. Tank
3
Too much dust will tear the bag easily, so do not
•
collect the dust more than the half of the bag
capacity.
Emptying the polyethylene bag
WARNING:
Always make sure that the cleaner is switched off
•
and unplugged before emptying the polyethylene
bag. Failure to do so may cause an electric shock
and serious personal injury.
CAUTION:
Do not apply a great impact on the powder filter and
•
tank. Applying a great impact may cause
deformation and damage to powder filter and tank.
Empty the tank at least once a day although this
•
depends on picked-up dust volume in the tank. Or,
the suction force will weaken and the motor may be
broken.
Do not grab the hook when emptying the tank.
•
Grabbing the hook may cause the hook to break.
011600
Unhook and lift up the tank cover.
011602
Shake off the dust from powder filter, damper and
prefilter and then take the polyethylene bag out of the
tank.
NOTE:
Take the polyethylene bag carefully out of the tank
•
so that the polyethylene bag cannot be caught and
torn by the protrusion inside the tank when
emptying it.
Empty the polyethylene bag before it becomes full.
•
Too much dust in the tank may cause the
polyethylene bag to be torn.
9
1. Tank cover
1
2. Polyethylene
bag
2 3. Hook
3