SPECIFICATIONS Model VC1310L / VC2510L / VC3210L Countries AU / GB / AR / Middle East 230V countries and 110V Africa Voltage Volt 230 - 230 - 230 - 230 - 220 - 230 - Power consumption Watt 1050 1050...
Page 3
Designation of Machine: OF GASOLINE, GAS, PAINT, ADHESIVES OR Vacuum Cleaner OTHER HIGHLY EXPLOSIVE SUBSTANCES. Model No./ Type: VC1310L, VC2510L, VC3210L The switch emits sparks when turned ON Conforms to the following European Directives: and OFF. And so does the motor commutator 2006/42/EC during operation.
24. REPLACEMENT PARTS. When servicing, use FUNCTIONAL DESCRIPTION only identical replacement parts. 25. STORE IDLE CLEANER. When not in use, the cleaner should be stored indoors. WARNING: 26. Be kind to your cleaner. Rough handling can • Before plugging the cleaner, always make sure cause breakage of even the most sturdily built that the cleaner is switched off.
Auto-suction stop during suction operation WARNING: • Do not use for a long time while the float is at work. Using the cleaner with its float at work for a long time can cause overheat, resulting in the cleaner deformation. •...
Page 6
Locking or unlocking the caster ► 1. Power supply cord 2. Base hook For Models VC1310L and VC2510L 2. Storing the front cuffs Front cuffs 22, 24 and 38 can be stored (up to two at a time.) ►...
To lock the caster with a stopper, lower the stopper lever and the caster no longer will rotate. To release the caster from the locked position, raise the stopper lever. Locking the caster is convenient when storing the cleaner, stopping the work on the way and keeping the cleaner still.
Page 8
Press the A section with a great force and with the A section so pressed lower the pipe holder. For Model VC1310L only ► 1. Tank cover 2. Protrusion of the pipe holder ► 1. Cord hook 3. Groove Depress the cord hook as shown in the figure.
Page 9
Connecting a hose CAUTION: • Never force the hose for bending or stamp it. Never move the cleaner by a hose. Forcing, stamping and pulling the hose may cause a breakage or deformation of the hose. • When picking up large wastes such as planer carvings, concrete dusts or similars other than small wastes, use the 38 mm inner diameter hose (optional accessory).
Page 10
► 1. Polyethylene bag 2. Holder plate 3. Tank Shake off the dust from powder filter, damper and prefil- ter and then take the polyethylene bag out of the tank. Spread the bag around the top of the tank. NOTE: Hook up the other side of the bag around the top of the tank so that the prefilter hook can catch and hold it •...
Storage of power supply cord ► 1. Cord hook 2. Power supply cord For Model VC1310L only ► 1. Power supply cord 2. Base hook Wind up the power supply cord around the base hook. ► 1. Cord hook 2. Power supply cord...
Applying an excessive force to these accessories may cause damage to the pipe holder. For Model VC1310L only Pipe rest can be used to store straight pipe, bent pipe ► 1. Straight pipe 2. Corner nozzle 3. Pipe holder and others by just inserting these accessories.
• These accessories or attachments are recom- mended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
Need help?
Do you have a question about the VC1310L and is the answer not in the manual?
Questions and answers