Maintenance - Makita VC1310L Instruction Manual

Installing powder filter
6
1. Tank cover
2. Powder filter
3. Damper
4. Prefilter
5. Tank
6. Mounting position marking
011637
Place the prefilter in the tank.
Next, mount the damper on the powder filter and then
place it in the prefilter.
When installing powder filter and prefilter, the mounting
position marking on each of them are aligned with that
one at the top of the tank.
Finally, mount the tank cover.
NOTE:
Models VC2510L and VC3210L have no mounting
•
position marking and no need to align it.
Before using the powder filter, make sure that
•
prefilter and damper are always used together. It is
not allowed to install powder filter solely.
Before using the paper pack, make sure that
•
powder filter, damper and prefilter are always used
together.
Carrying the cleaner
1
2
011610
When carrying the cleaner, carry it by holding the handle
on the head as shown in the figure. The handle is
3
retractable at the head when not in use.

MAINTENANCE

4
CAUTION:
Always be sure that the tool is switched off and
•
5
unplugged before attempting to perform inspection
or maintenance.
Storage of power supply cord
For Model VC1310L only
011633
011597
Pull out the cord hook or open the base hook. Wind up
the power supply cord and hang it on the cord hook or
wind it around the base hook.
NOTE:
Do not force the power supply cord off the cord
•
hook when trying to disconnect it from there.
Forcing power supply cord to disconnect from the
cord hook may cause damage to the cord
10
1. Handle
1
2. Head
2
1. Cord hook
1 2. Power supply
cord
2
1. Power supply
1
cord
2. Base hook
2