Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer FH-P9200MP Operation Manual

Audio Adjustments
M HPF: 31.540506380100125
160200 (Hz)
M LPF: 1.622.53.15456.38
1012.516 (kHz)
H HPF: 1.622.53.15456.38
1012.516 (kHz)
4 Press a or b to adjust the level of the
selected speaker unit (filter).
Each press of a or b increases or decreases
the level of the selected speaker unit (filter).
0dB  24dB is displayed as the levelis in-
creased or decreased.
+6dB  24dB is displayed as the levelis in-
creased or decreased, only if you haveselected
L LPF.
5 Press SLOPE to select the slope of the
selected speaker unit (filter).
L LPF: 12 18 6 (dB/oct.)
M HPF: 12 18Pass (0) 6 (dB/oct.)
M LPF: 12Pass (0) 6 (dB/oct.)
H HPF: 12 6 (dB/oct.)
6 Press PHASE to switch the phase of the
selected speaker unit (filter).
Each press of PHASE switches the phase be-
tween normal and reverse
# You can adjust the parameters for other
speaker units (filters) in the same way.
7 Press BAND to cancel the network ad-
justment mode.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1
SW1 to select the subwoofer output mode.
# SW2 is displayed only when the subwoofer
output is on in the subwoofer output mode
(SW1).
2
on.
SUB.W ON appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press SW1
again.
3
woofer output.
Press c to select reverse phase. Press d to se-
lect normal phase.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1
SW2 to select the subwoofer setting mode.
.
2
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6  24 is dis-
played as the level is increased or
decreased.
Press AUDIO and NEXT and then press
Press SW1 to turn subwoofer output
Press c or d to select the phase of sub-
Press AUDIO and NEXT and then press
Press c or d to select cut-off frequency.
Press a or b to adjust the output level
Section
11
49
En