Signal; Setting The Time Signal Display; Changing The Display Form; Adjusting The Brightness - Pioneer FH-P9200MP Operation Manual

Other Functions
3 Press JUST to match the time to a time

signal.

If the minute is 00  29, the minutes are
rounded down. (e.g., 10:18 becomes 10:00.)
If the minute is 30  59, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
Note
During date adjustment, JUST is not displayed.

Setting the time signal display

You can display the time signal display, which
announces every full hour with a sound and
ananimation.
1 Press NEXT to display CLK.
Press NEXT until CLK appears.
2 Press CLK and then press T.SGNL to se-
lect the time signal display.

Changing the display form

This unit is equipped with two basic displays.
You can select the desired display.
1 Press NEXT to display C.MENU.
Press NEXT until C.MENU appears.
2 Press C.MENU and then press D.FORM
to select the display form mode.
3 Press FORM1, FORM2 or FORM3 to se-
lect the desired display form.

Adjusting the brightness

Display brightness adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Press NEXT to display C.MENU.
Press NEXT until C.MENU appears.
2 Press C.MENU and then press BRGHT to
select the brightness mode.
3 Press c or d to adjust the brightness
level.
Each press of c or d increases or decreases
the brightness level. 00  28 is displayed as
the level is increased or decreased.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can switch dimmer on or off.
1 Press NEXT to display C.MENU.
Press NEXT until C.MENU appears.
2 Press C.MENU and then press DMMER
to select the dimmer mode.
3 Press DMMER to turn the dimmer on.
ON appears in the display.
# To turn the dimmer off, press DMMER
again.

Setting the flash light screen

There are four stored flash light screen to se-
lect from.
Section
13
61
En