Additional Information; Understanding Built-In Cd Player Error Messages; Understanding Built-In Md Player Error Messages; Understanding Auto Ta And Eq Error Messages - Pioneer FH-P9200MP Operation Manual

Additional Information

Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears on the display refer to
the table below to see what the problem is and
the suggested method of correcting the pro-
blem. If the error cannot be corrected, contact
your dealer or your nearest Pioneer Service
Center.
Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-10, 11, Electrical or me-
12, 17, 30, A0 chanical
ERROR-22, 23 The CD format
cannot be played
back
ERROR-44 All tracks are
skip tracks
Understanding built-in MD
player error messages
When problems occur during MD play an
error message may appear on the display. If
an error message appears on the display refer
to the table below to see what the problem is
and the suggested method of correcting the
problem. If the error cannot be corrected, con-
tact your dealer or your nearest Pioneer Ser-
vice Center.
Action
Clean disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
Replace disc.
Replace disc.
Message Cause
Blank MD Blank disc is in-
serted.
TEMP The temperature
of this unit is out-
side of the nor-
mal operating
range
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-01, 11, Electrical or me-
12, 17, 30, A0, chanical
A1
ERROR-20, 21 Track information
cannot be read.
ERROR-20, 21, There is some-
24 thing wrong with
the MD.
ERROR-23 The MD contains
recorded infor-
mation other
than music.
ERROR-A1 Electrical or me-
chanical
ERROR- MD play not pos-
sible.
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears on the display refer to the table below to
see what the problem is and the suggested
method of correcting the problem. After
checking, try again.
Appendix
Action
Replace disc.
Wait until the
units temperature
returns to within
normal operating
limits.
Clean disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the MD
player.
Reload the MD.
Replace disc.
Replace disc.
Press RESET.
Replace disc, or
press RESET.
65
En