AEG CTV 4894 DVB-T/DVD Instruction Manual page 53

Antenna connections
Inputs on the side of the device
Switching on the player (Fig. 2/20)
05-CTV 4894_GB.indd 53 05-CTV 48 _GB.indd 53
Antenna Input (Fig. 2/13)
NOTE:
Please ensure that it is possible to receive DVB-T signals in your area.
Information on the transmission area is available on the Internet un-
der: http://www.ueberallfernsehen.de, or from your specialist dealer.
This device has a built-in DVB-T receiver.
In order to be able to receive digital terrestrial channels with the built-in
DVB receiver it is necessary to connect your permanently installed house
aerial.
If you are located in the central section of the transmission area you can
also use an optional passive or active DVB-T aerial.
• Connect the cable from your DVB-T aerial system or your DVB-T room
aerial to the ANT. socket on the left-hand side of the device.
This device also has a built-in analogue receiver.
In order to be able to receive cable television channels with the built-in
analogue receiver it is necessary to connect your permanently installed
cable system.
For this you should connect the cable of your cable connection to the
ANT. socket on the left-hand side of the device.
USB Input (on the left-hand side of the device) (Fig. 2/22)
Insert a USB storage medium into the corresponding socket on the left-
hand side of the device.
Memory Card Slot (on the left-hand side of the device) (Fig. 2/21)
Insert an MMC/SD or MS storage card into the card slot on the left-hand
side of the device.
Turn on the main switch of the DVD player by moving the „POWER I/O"
switch on the left-hand side of the device to the „I" position.
English
53
20.03.2008 12:01:10 Uhr 20.03.2008 12:01:10 Uhr