Connection To Other Equipment - AEG CTV 4894 DVB-T/DVD Instruction Manual

Lcd tv/dvd player with dvb-t receiver
Table of Contents

Advertisement

Available languages

Available languages

C. With the rechargeable battery
Connection to a television set
(Fig. 2/15)
05-CTV 4894_GB.indd 51
05-CTV 48
_GB.indd 51
While you are driving the vehicle it is forbidden to adjust the device or
watch videos and CDs.
If the cigarette lighter is dirty, poor conductivity will make the
connection hot. Please ensure that the adapter is only inserted into a
clean cigarette lighter connection.
After use the adapter should be removed from the device and from
the cigarette lighter socket.
Charge up the battery before initial use.
The rechargeable battery is intended for portable use and for the
viewing of DVDs out of doors.
Recharging the Battery
1. Insert the cable from the alternating current adapter into the DC IN
9V socket (Fig. 2/18) of the device.
2. Connect the alternating current adapter to a properly installed shock-
proof socket. The charging display lights up in red (Fig. 2/19).
ATTENTION:
The alternating current adapter supplied is only intended for use
with this device. Do not use it for other equipment.
If the device is not going to be used for a prolonged period the
mains lead must be removed from the power socket.
The battery is fully charged when the CHARGE control lamp changes to
green. Remove the mains lead from the alternating current adapter and
then the battery from the charging device.
NOTE:
If the power of the rechargeable battery falls, playback stops.
If the device switches itself off during operation the battery is fl at.
The battery has to be charged up.
Only the original adapter and the original charging device should be
used to charge up the battery.
Charge up the battery shortly before the next time it is used.

Connection to Other Equipment

1. Insert the cinch cable into the corresponding sockets on the device.
2. Connect the other end of the cinch cable to your television set. If
necessary you should use an RCA/start adapter (not included in the
scope of supply).
3. Turn the AV IN/OUT switch (Fig. 2/14) to „OUT".
Playback of a DVD on the Television Set
1. Turn on the DVD player by the POWER I/O switch.
2. Turn on the television set and follow the instructions supplied with
the television set.
English
51
20.03.2008 12:01:09 Uhr
20.03.2008 12:01:09 Uhr

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Ctv 4878Ctv 4894

Table of Contents