Installation Requirements; Tools And Parts; Options; Location Requirements - Kenmore 592-491070 Owner's Manual And Installation Instructions

Tools and Parts

Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
■ Pliers
■ Flashlight (optional)
Tools needed for installation
■ Open end wrenches 17 mm and 13 mm
■ Level
■ Wood block
■ Ruler or measuring tape
Parts supplied
Wrench
Hose guide
Alternate Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call 1-800-4-MY-
HOME® (1-800-469-4663).
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller than available)
96" (2.4 m)
Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Drain hose too short 3.3 ft (1.0 m) drain hose extension kit,
Part Number DC82-01012A
Kenmore_Washer_Good-02681B-02_EN.indd 5

INSTALLATION REQUIREMENTS

(use for the upper bolt hole)
Bolt hole covers
Water supply hose

Options

Pedestal
You have the option of purchasing a pedestal for this washer.
You may select a 10.6" (27 cm) pedestal. Remember that the
pedestal will add to the total height of the unit.
Optional pedestal
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME® (1-800-469-4663).
Pedestal Approximate height
Height with washer
10.6" 48" (122 cm)
(27 cm)
10.6" 48" (122 cm)
(27 cm)
10.6" 48" (122 cm)
(27 cm)
10.6" 48" (122 cm)
(27 cm)
Stack Kit
Are you on planing stage to stack your Kenmore washer and dryer?
To do so , purchase an optional stack kit (Model:592-188800)
from your local Sears store or Sears Service Center. Follow
instructions included with the kit. See "Location Requirements."

Location Requirements

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See "Drain
System."
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
■ A water heater set to deliver 120°F (49°C) water to the
washer.
■ A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
■ Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of 20-100
psi (137.9-689.6 kPa).
Color Model
Number
Imperial- 592-190070
Silver
Blue- 592-190080
Silver
Tango- 592-190040
red
Night Sky 592-190090
Blue
5
2009-07-23 ¿ÀÈÄ 4:17:56