Installation Requirements; Tools And Parts; Location Requirements - Kenmore ELITE TRIPLE SMART 8567021 Use And Care Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and
water inlet hoses:
• Pliers that open to 1°/16 '' (3.95 cm)
• Flashlight (optional)
Parts supplied:
D E
A. Drain hose
B. Silver, double-wire hose clamp
(for the bottom of the drain
hose)
C. Yellow, single-wire hose clamp
(for the top of the drain hose)
D. Water inlet hoses (2)
E. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and
leveling the washer:
• Adjustable or open end wrench °/16"(14 mm)
• Level
• Wood block
• Ruler or measuring tape
Parts supplied:
B
A. Shipping strap with fastener
B. Front leveling feet with nuts (2)
Alternate Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME ® (1-800-469-4663}.
If You Have: You Will Need to Buy:
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
1" (2.5 cm) 2" (5 cm) diameter to 1" (2.5 cm)
diameter diameter standpipe adapter,
standpipe Part Number 3363920
Overhead sewer Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Floor drain Siphon break, Part Number 285320;
additional drain hose,
Part Number 3357090 and connector
kit, Part Number 285442
Water faucets 2 longer water fill hoses:
beyond reach of 6 ft (1.8 m) Part Number 76314,
fill hoses 10 ft (3.0 m) Part Number 350008
Drain hose too Drain hose, Part Number 388423 and
short hose kit, Part Number 285442
Drain hose that is Hose kit, Part Number 285442
too long
Lint clogged drain Drain protector, Part Number 367031
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed in a basement, laundry room,
closet, or recessed area. See "Drain System."
IMPORTANT: Do not install or store the washer where it will be
exposed to the weather.
Proper installation is your responsibility.
You will need:
• A water heater set to deliver 120°F (49°C) water to the
washer.
• A grounded electrical outlet located within 4 ft (1.2 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."