Kenmore 592-491070 Owner's Manual And Installation Instructions page 6

■ A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
■ A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Installation clearances
■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90° and
it is not reversible.
■ Additional clearances might be required for wall, door, and
floor moldings.
■ Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
50"
(127 cm)
Washer Dimensions
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
37" min.
(93.9 cm)
(2.5 cm)
6
Kenmore_Washer_Good-02681B-02_EN.indd 6
27"
(68.6 cm)
38.2"
(97.1 cm)
31"
(78.6 cm)
Door is not reversible
1" 27" 1"
(68.6 cm) (2.5 cm)
Recommended installation spacing for recessed or closet
installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
48 In.
48"
(310 cm
(122 cm)
24 In.
(155 cm
1" 29¼" 4"
(2.5 cm) (80 cm) (10.2 cm)
A
A. Side view - closet or confined area
B. Closet door with vents
* Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
1" 27" 1"
(2.5 cm) (68.6 cm) (2.5 cm)
A
A. Recessed area
B. Side view - closet or confined area
3"
(7.6 cm)
2 *
)
2
2 *
) 3"
2
(7.6 cm)
B
38" min.
(97 cm)
1" 29¼" 4"
(2.5 cm) (80 cm) (10.2 cm)
B
2009-07-23 ¿ÀÈÄ 4:17:58