Club Car XRT 850 Owner's Manual page 24

Controls and Indicators
78
Figure 13 Brake Pedal
PARK BRAKE PEDAL
The park brake pedal is the small raised portion in the upper left corner of the brake pedal. It has the word PARK
molded into it and the words PARK BRAKE marked on top of it (Figure 13). To set the park brake, press the brake
pedal firmly and tilt the park brake portion of the pedal forward with your foot (Figure 14). See following WARNING.
WARNING
• The park brake will release automatically when either the accelerator or brake pedal is pressed. The
park brake has multiple locking positions and should be firmly pressed and locked to prevent the
vehicle from rolling.
TOW/RUN SWITCH
Electric Vehicles Only
WARNING
• Place Tow/Run switch in the TOW position before disconnecting or connecting the batteries. Failure to
heed this warning can result in a battery explosion or severe personal injury.
• When the Tow/Run switch is in the TOW position, all motor braking functions, including walk-away
braking, are disabled.
Electric vehicles are equipped with a Tow/Run switch, located on the seat support panel under the seat (Figure 15).
The switch must be in the RUN position in order to operate the vehicle. When the switch is in the TOW position, power
to the vehicle electrical components is turned off and the vehicle will not operate. See following NOTE.
NOTE: After placing the Tow/Run switch in the TOW position, allow 10 seconds to elapse before switching back to
the RUN position.
After placing the Tow/Run switch in RUN position, allow 10 seconds to elapse before operating the vehicle.
The Tow/Run switch should be placed in the TOW position under the following conditions:
Page 22 XRT 850 Electric and Gasoline Vehicle Owner's Manual
79
Figure 14 Park Brake Pedal