Advertisement
DESCRIPTION OF PARTS
1. Motor base
2. Control switch
0 Stop / no power
1 Low speed
2 High speed
3. Safety locking arms
4. Pulp container
5. Pulp chute/ Juicer cover
6. Food pusher
7. Juicer collector assembly
8. Juice jug
9. Rubber feet
10. Spout cover
11. Light indicator
12. Stainless steel grater and filter
13. Feeder tube
ASSEMBLE THE APPLIANCE
(Figure 1)
(Figure 2)
•
Place the motor base on a stable surface.
•
Place the spout cover on the motor base with
the spout hole at the right hand side (facing the
direction of the safety locking arms).
•
Swivel the spout cover until it fits on the motor
base.
•
Insert the juicer collector assembly on the spout
cover.
•
Hold the stainless steel grater and filter
assembly as per figure 2.
•
Install the stainless steel grater and filter
assembly into the motor base.
•
Twist the filter assembly and gently push down
until it is seated on the motor base.
NOTE: The top edge of the grater should not be
higher than the edge of the juice collector assembly
when properly installed.
Advertisement
