Assembly & Inflation - Sea Eagle 435PS Instruction & Owner's Manual

Assembly & Inflation
Crossbar Yokes
The PaddleSki features
3 aluminum crossbars
(pre-assembled) that
support the pontoons
and the floor. These
crossbars do not need
to be extremely tight,
however they should
not be allowed to loosen
too much over time.
Locate a relatively clean
space to unpack your
Sea Eagle. Inflate both
of the pontoons and
then get ready to attach
the seats.
Deluxe Inflatable Seat
Inflate the seat so that
its reasonably hard. You
should be able to push
your finger about 3/4"
You can also change
the center of gravity by
deflating the bottom
portion of the seat. A
softer bottom equals a
lower seating position.
One-Way Air Valve
The deluxe seat use
deluxe one-way air
valves for inflation.
The deluxe seat has
separate inflation
chambers for both the
back and bottom of the
seat. You will also need
a separate adapter to
inflate the deluxe seat.
Assembly & Inflation
6
The triple nozzle
adapter comes with the
A-41 foot pump. Inflate
the deluxe seat with the
large rounded adapter
on the triple nozzle with
the A-41 foot pump. The
seat is low pressure and
only requires a few
pumps with the A-41. To
deflate, simply unscrew
the valve from the base.
Attach the seat clips on
to the D-Rings on your
Sea Eagle. Adjust the
straps on the seat for
comfort. If you're solo
paddling, position your
seat in the bow of your
Sea Eagle.
Tall Back Seat
This seat has two sets
of straps (front and
back). Attach the seat
clips to the D-Rings on
your Sea Eagle. Adjust
the straps on the seat
for comfort. If you're
solo paddling, position
your seat in the bow of
your Sea Eagle.
TIP: Its important when
getting in that you place
your weight on the seat
pad while trying not to
knock back the upright
backrest pad. This may
take a little practice, but
is very easy and keeps
the tall back seat in the
proper position so that it
provides maximum back
support.