Table of Contents
Advertisement
FastTrack|
SETUP: VALVES & PUMPS
To connect the pump
to a 12V battery, use
the alligator clips.
Connect the red clip to
the positive pole and
the black clip to the
negative pole.
WARNING:
Always connect the red
clip to the positive
pole and the black clip
to the negative pole.
Cross connecting wires
could damage both the
pump and the boat.
WARNING:
Air compressors that are
designed for other uses
like tire inflation (usually
over 30 psi) can easily
over-inflate and cause
harm to your Sea Eagle
that uses a much lower
pressure. For this reason,
we recommend using only
Sea Eagle electric pumps.
FastTrack |
ASSEMBLY & INFLATION
Locate an area large
enough to unfold the
385fta avoiding hazards
that could damage the
kayak or injure you.
Remove plastic base stick
from skeg base. Base stick
keeps base from
warping when boat is
tightly folded.
Slide skeg into base.
Secure skeg with clip. If
skeg will not slide into
the base, do not force it.
Refer to troubleshooting
section. Do not use skeg
in whitewater.
Starting with the sides,
insert the adapter into the
valve, turn it to the right
until it is fully seated and
then begin inflation.
Valve stem should be in
the up position
7
Advertisement
Table of Contents
