Installing The Modem Using Wireless - Ubee U10C019 User Manual

6
connect your PC or MAC to the Internet. All you need is an 802.1 1b/g wireless client
that is connected to your PC or MAC. Depending on your cable service provider, you
may be able to connect multiple wireless clients to your wireless cable modem. Using
the USB port allows you to install the wireless cable modem more quickly and easily
than using the Ethernet port, because you do not have to install and configure a network
interface card (NIC). USB, however, only enables you to connect one computer to the
wireless cable modem. Using the Ethernet port allows you connect multiple computers
to a wireless cable modem through the use of additional equipment, which is not
included. Please contact your cable service provider for more information on using
multiple computers.
3. Installing the Modem Using
Wireless
This chapter explains the process for installing your wireless cable modem using the wireless
feature. First you will install the hardware (wireless cable modem, wireless client (not
included), coax cable (not included), and power adapter).
Installing the Hardware
This section explains how to connect the wireless cable modem to the computer, wall
cable outlet, and electrical outlet. To install the hardware:
Power off the computer
Connect one end of the coaxial cable to the wireless cable modem's cable connector.
Connect the other end of the coaxial cable to the cable wall outlet. Be sure not to bend
or over tighten the cables as this may strain the connector and cause damage. If you
plan to connect the wireless cable modem and television to the same wall outlet, you
must use a cable line splitter (not included).
Plug the wireless cable modem's power adapter into the wireless cable modem's
power jack and into an electrical outlet or surge protector.
Follow the installation and configuration instructions included with your wireless client.
You are now ready to use your cable modem.
U10C019/U10C020

Installing the Modem Using Wireless