Removing The Rj-11/Rj-45 Board - Dell Inspiron 2500 Factory Service Manual

Removing and Replacing Parts : Dell Inspiron 2500 Systems
2. Remove one or both of the plastic connector covers (one or both of the covers may be installed) by slipping
a nonmarring tool into the cutout at the top and pivoting the tool up to disengage the inner securing tab.
To replace a connector cover, orient the cover notch-side-up and snap it into the connector cutout.

Removing the RJ-11/RJ-45 Board

1. Follow the instructions in
2. Remove the system
3. Remove the 4-mm screw from the RJ-11/RJ-45 board.
NOTICE: The plastic tab is fragile; pull it back only far enough to remove the board
assembly.
4. Reach into the enclosure and, while pulling the tall plastic tab away from the board assembly to release it,
lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness by routing it between the plastic
posts as shown in the following figure.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...hecked%20ok/Inspiron/2500/2500%20SM/remove.htm (45 of 46)6/21/2004 12:45:37 AM
"Preparing to Work Inside the
board.
Computer."