Dell Inspiron 2500 Factory Service Manual page 94

Removing and Replacing Parts : Dell Inspiron 2500 Systems
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an
unpainted metal surface on the computer.
Removing the Display Assembly Bezel
1. Follow the instructions in
2. Use a scribe to pry loose the four rubber screw covers located across the top of the bezel.
3. Remove the four 4-mm screws located across the top of the bezel.
4. Use a scribe at the indentations to pry loose the two rubber screw covers located at the bottom of the
bezel.
5. Remove the two 4-mm screws located at the bottom of the bezel.
6. Separate the bezel from the display-assembly top cover.
The bezel is secured to the display assembly top cover with plastic tabs around the sides. Use a plastic scribe
to help separate the bezel from the top cover.
Removing the Display Panel
1. Remove the hinge
2. Remove the screw securing the flex cable to its strain relief, and then use the pull loop to remove the flex
cable from the system board.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...hecked%20ok/Inspiron/2500/2500%20SM/remove.htm (25 of 46)6/21/2004 12:45:37 AM
"Preparing to Work Inside the
cover.
Computer."