Sony CDX-GT520 Operating Instructions Manual page 16

•
16
Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.
MPEG
Layer-3 audio coding technology and
patents licensed from Fraunhofer lIS and Thomson.
Design and specifications are subject to change
without notice.
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Halogenated flame retardants are not used in
cabinets.
• Packaging cushions are made from paper.
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
General
No power is being supplied to the unit.
• Check the connection. If everything is in order, check
the fuse.
• If the unit is turned off and the display disappears, it
cannot be operated with the remote commander.
---+ Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The volume is too low.
• The ATT function is activated.
• The position of the fader control "FAD" is not set for
a 2-speaker system.
• The CD changer is incompatible with the disc format
(MP3/wMA/AAC).
---+ Play back with a Sony MP3 compatible CD
changer, or this unit.
No beep sound.
• The beep sound is canceled (page 10).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
---+ Store again into the memory.
• The power supply lead or battery has been
disconnected.
• The power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
---+ Set "DEMO-OFF" (page 10).
The display disappears from/does not appear
in the display window.
• The dimmer is set "DIMMER-ON" (page 10).
• The display disappears if you press and hold (
OFF).
---+ Press and hold
(OFF)
on the unit until the
display appears.
• The connectors are dirty (page 14).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
---+ Turn off the unit.
Card remote commander operation is not
possible.
Make sure the insulation film has been removed
(page 4).
DSO does not function.
Depending on the type of car interior or type of music,
DSO may not have a desirable effect.
CD/MD playback
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 13).
MP3IWMAlAAC files cannot be played back.
The disc is incompatible with the MP3/WMAI AAC
format and version (page 13).
MP3IWMAlAAC files take longer to play back
than others.
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "A.SCRL" is set to "OFF".
---+Set "A.SCRL-ON" (page 10).
---+ Press and hold (
DSPL)
(SCRL).
The sound skips.
• Installation is not correct.
---+ Install the unit at an angle of less than 45
0
in a
sturdy part of the car.
• Defective or dirty disc.