Installation - LevelOne FCS-0010 User Manual

Installation

1. Assemble the Camera
For WCS-0010, screw the supplied antenna to the mounting point on the rear.
Attach the Camera Mount to the camera.
2. Connect the LAN Cable
Connect the FCS-0010/WCS-0010 to a 10/100BaseT hub or switch, using a
standard LAN cable.
For the WCS-0010 Network Camera, this disables the Wireless
Interface, because only one interface can be active.
The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching the
LAN cable while the camera is powered on does NOT switch
the interface between wired and wireless.
3. Power Up
Connect the supplied 5Vpower adapter to the FCS-0010/WCS-0010 and power up.
Use only the power adapter provided. Using a different one may cause hardware
damage.
4. Check the LEDs
•
The Power LED will turn on briefly, then start blinking. It will blink during startup,
which takes 15 to 20 seconds. After startup is completed, the Power LED should
remain ON.
•
The Network LED should be ON.
For more information, refer to Physical Details in Chapter 1.
8