Lp Conversion Instructions - Travis Industries Green Smart Owner's Manual

LP Conversion Instructions

The GSR Stepper Motor Kit (SKU 94400999) is required for converting this appliance to LP. The
kit contains the stepper motor (regulator), torx wrench, and pilot orifice. The burner orifices and
burner gaskets are shipped with the appliance.
WARNING
This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority having
jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or
production of carbon monoxide may result causing property damage, personal injury or loss of
life. The qualified service agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the converted appliance is checked
as specified in the manufacturer's instructions supplied with the kit.
CAUTION:
The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding
with the conversion.
IMPORTANT:
A converted appliance must have a label attached marked with the following:
"This appliance was converted to _____ gas with Kit No. _____ by _____ (name and address of
organization making the conversion), which accepts the responsibility that this conversion has
been properly made. This control has been converted for use with gas_____."
Convert the appliance prior to installing the gas line to ensure proper gas use.
1 Access the firebox.
3 Remove and discard the manifold cover (see below).
© Travis Industries
Index
4120301
43
100-01286_000