Before You Begin; Remote Set-Up; Verify The Fan Control Module Is On; Synchronize The Transmitter To The Receiver - Travis Industries Green Smart Owner's Manual

Before You Begin


Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.

Remote Set-Up

Verify the Fan Control Module is On

The fan control module has a power switch. Make sure it is in the ON ("-") position (see
switch must remain in the ON position for the AC components to operate (Accent Light and Optional
Blower). The module also supplies low-voltage for the fireplace controller. By leaving it in the OFF
position, the fireplace will operate off the receiver batteries, greatly diminishing battery life.

Synchronize the Transmitter to the Receiver

The transmitter will need to be synchronized to the receiver before the remote will work correctly.
Synchronizing is done in the following two steps below (see
a) Press the PRG (Program) button on the receiver using a paperclip or equivalent device (receiver
will beep 3 times).
b) Press the "ON" button on the transmitter (receiver will beep 4 times).
NOTE: If power is cut off to the receiver for an extended period of time, you may need to re-synchronize
the remote.
© Travis Industries
Operation
"Beep"
"Beep"
"Beep"
4120301
"
):
Figure 2
====
27
). This
Figure 1
Figure 1
"Beep"
"Beep"
"Beep"
"Beep"
Figure 2
100-01286_000