Table of Contents
Advertisement
l
Mic/Line input — One 3-pole captive screw connector switchable between mic
and line level inputs. Wire the connector as shown below (see figure 4). Use the
configuration software to select the mic or line input level.
Tip
Ring
Sleeve
Balanced Input
Figure 4.
3.5 mm, 3-pole Captive Screw Microphone Connector
ATTENTION:
wires are not as secure in the connector and could be pulled out.
Figure 5.
Mic/Line Rear Panel Connection
NOTE: Although the rear mic/line input is 5-pole, only 3 poles are used by the
mic/line connector. Be certain to plug the 3-pole mic/line connector into the
correct position.
m
Mute HDMI Audio and Phantom Power— Two 2-position DIP switches.
The MUTE HDMI AUDIO switch (see figure 6) mutes the HDMI embedded audio on both
the HDMI output and the DTP output when the switch is in the UP position.
The PHANTOM POWER switch selects +48 V phantom power for the mic input when in
the UP position.
L
1
R
L
2
R
L
3
R
L
4
R
L
5
R
MIC LINE
Figure 6.
Mute HDMI Audio and Phantom Power DIP Switches
" (5 mm) MAX. (typ)
3
16
Tip
Sleeve
Jumper
Unbalanced Input
Audio INPUT Wiring
Do not tin the wire leads before installing into the connector. Tinned
L
L
3
3
R
R
MIC LINE
MPS 602 • Installation
7
Advertisement
Table of Contents
