Invacare Tornado Service Manual page 50

Service Manual
•
Unscrew valve cap.
•
Depressurise tyre by pressing in the pin in the valve .
•
Remove the 5 cylinder head screws (back of the
wheel, 2.
•
Remove the rim halves from the tyre.
•
Remove the inner tube from the tyre.
•
Repair inner tube and replace, or insert a new one.
NOTE
If the old inner tube is to be repaired and re-used, and has become wet during repair, you can
make replacement easier by sprinkling the inner tube with a little talcum powder.
NOTE
Re-assembly is done in reverse order. Ensure that the tyre is replaced on the same side and in
the same travel direction as it was previously mounted.
•
Insert the wheel rim halves from outside into the tyre.
•
Pump a little air into the inner tube.
•
Insert the cylinder head screws in the rim and tighten the wheel rims firmly.
•
Ensure that the tyre outer is seated correctly.
•
Pump the tyre up to the prescribed pressure.
•
Check that the tyre is seated correctly once again.
•
Screw the valve cap back on.
•
Refit the wheel.
As at: 19.03.2004 Page 49
Tornado