Invacare Tornado Service Manual page 31

Tornado
•
Move the lifter to the uppermost position.
•
Raise the lifter just a little more so that the
retaining mechanism (1) locks into place.
•
Check whether the retaining mechanism (1)
is fully locked into place.
•
Move the regulating motor to the lowest
position. The regulating motor slides out of
the upper guiding device.
•
Use a 5mm or 6mm hexagon socket to
unscrew the screws (1) and (2) on both
sides of the vehicle.
•
Remove the front panelling to the front.
•
Open the plug-in connection on the
regulating motor cable.
•
Pull the nest together with the regulating
motor slightly to the front (1) and then lift (2).
Now remove the regulating motor and the
nest completely.
•
Open the electronic panelling. In doing so,
push the rear side panelling away slightly
using a large, flat screwdriver.
Page 30
Service Manual
As at:19.03.2004